Controllers
4001S-5041 controller
This controller features the minimum conversion time – approximately 16 ms per coordinate set (including transmitting time). Electrical and physical specifications of the controller are standard for this type of goods that allows using it without additional system modifications.
Technical data
Electrical parameters
+12 VDC, nominal (+9 VDC - +15 VDC)
85 мА at +12В
Average power dissipation - 1 W
Power supply must be capable of sourcing minimum 200 мА
Total noise requirements must be less than 100 mV (p-p) for frequency below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz
Interface
EIA 232E (Serial RS232), DCE configuration, 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex
Baud rate
9600
Touch resolution
4096х4096, size independent, 256 levels of Z axis (pressure)
Conversion time
approximately 16 ms per coordinate set (including transmitting time)
Plug-in & Plug-out
PnP protocol compatible
Supply management
ACPI compatible
Reliability
MTBF greater than 200,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 40°С
Environmental temperature
operating: 0°С to 65°С
storage: -25°С to 85°С
Humidity
operating: 10% to 90% RH, non-condensing
storage: 10% to 90% RH, non-condensing
ESD
per EN 6100-4-2: contact discharge 4KV, air discharge 8KV
Flammability
The printed circuit board substrate is rated 94V0. All plastic components, such as headers and connectors, are also rated 94V0.
Physical characteristics
Multi-layer surface-mount design with internal ground plane for EMI suppression
Dimensions
Total width: 62 mm, including connectors
Total length: 85 mm
Total height: 10.8 mm
Download driver:for Windows 2K/XP
Attention! Buy only genuine General Touch products from Plast Game company and our dealers. Beware of imitations!
|
RUS
ENG
enlarge image
